B10D Software

Back up to the VMG1312-B10D Page
From AAISP Support Site


Software History

Software on the ZyXEL web site may well be older than the version that we are using. Here are the details regarding software releases: (Latest first)

ZyXEL VMG1312 Software releases
Date Version Release Download Open Source Information
2017-06 V5.13(AAXA.5)C0 5 File:V513AAXA5C0.zip unknown The First Software A&A used
  • Usually applying the firmware yourself to an AAISP supplied router is not required or recommended. Updates can be applied via the Control Pages. The files are listed above for your information as they also include the release notes.
  • The 'Live' flag shows which version is currently being shipped by AAISP and will be sent to a router that has been factory reset.
  • 2015-07-17: We have been told "The scope for AAJZ7 [release 7] is already in discussion and we are pushing to get as many of A&A’s open tickets in to it"
  • The configuration file that we generate for your line will be based upon the 'live' software version. This means that if a router is running older software it will need to be upgraded before a new configuration can be sent.
  • See the VMG1312: Bugs page for problems we have found with the software and configuration.
  • Where possible we will request and the GPL'd software used and will add it to the table above, you may request it via ZyXEL GPL Page
  • ZyXEL host firmware for this router here: ftp://ftp.zyxel.com/VMG1312-B10D/firmware/

Manual Upgrading

Unzip the downloaded file. Log in to the router's web interface, go to:

Maintenance > Firmware Upgrade 

and follow the steps there, you'll be uploading the .bin file.

Control Page options for upgrading software

The control page will show if the current software version on the router and if it is up to date or not. If there is a new software version available then it can be upgraded:

 
Router action buttons. Upgrade button is only shown if a new version is available

Upgrading when in Bridge mode

When in bridge mode the ZyXEL router will not have access to the internet itself, and so won't have a way to upgrade in this state. To upgrade you need to reset the router by holding in the reset button. This then reverts the config back to our default, it will then log in, upgrade, then log in again and will get a new config sent to it. At that point it will be back to Bridge mode running latest software.