DGA0122 Disable SSH: Difference between revisions

← Older edit

DGA0122 Disable SSH (view source)

Revision as of 16:44, 24 December 2023

580 bytes added , 24 December 2023

m

Reference OpenWrt

Adsb

editor

471

edits

Revision as of 09:54, 4 June 2023 (view source) Adsb (talk \| contribs) m (Warn about the rtfd command) ← Older edit		Latest revision as of 16:44, 24 December 2023 (view source) Adsb (talk \| contribs) m (Reference OpenWrt)
(One intermediate revision by the same user not shown)
[[Category:Technicolor_DGA4134]] This probably applies to most Technicolor routers of the same era. ssh is enabled from the LAN, and can be accessed using the engineer user and the admin password. The CLI is fairly ~~minimal~~unfriendly, there is no manual. ~~:-(~~ The firmware is based on OpenWrt, and the '''get''' and '''set''' commands work like as in that firmware's UCI. N.B. If you choose to play with the CLI, the '''rtfd''' command will reset the router to factory default setting, without any warning or Y/N prompt. ssh can be disabled if you want, you can do this via ~~ssh. ssh in to~~ the ~~router~~web ~~and~~interface ~~paste~~(at ~~the~~least ~~following~~with ~~which~~firmware ~~will~~19.4) ~~disable~~or ~~the~~via ~~access:~~ssh. == Web method == Login to the router using the ''engineer'' username and admin password. Select the ''System Info'' tile and the ''Configuration'' tab. Turn ''Local SSH'' on or off. With Local SSH turned off, when you try to ssh, you'll get: ssh: connect to host 192.168.1.1 port 22: Connection refused To revert the change, use the above steps to turn Local SSH back on. == SSH method == ssh in to the router and paste the following which will disable the access: set InternetGatewayDevice.Services.X_000E50_AccessManagement.SSH.ServerAccess.1.Enable 0