Automatic Line Testing

From AAISP Support Site
Revision as of 09:06, 27 January 2014 by AA-Andrew (talk | contribs)

If you have a BT provided ADSL, FTTC or FTTP line, then nn the Control Pages you are able to set automatic line testing.

Clueless-auto-testing.png

Tests

  • For ADSL we will run a 'Status Test' - this will report back the sync speed, the profile, and errored seconds.
  • For FTTC and FTTP we will run an 'End to End' Test - this will report

UpDown Testing

We the line connects and drops we will run a test. This can be useful to see if it drops and stays in sync.

When set, we will run tests for 2 weeks.

Regular Testing

We can run daily or hourly tests. These can be useful to see variations in the quality of the line and for on going monitoring.

When set, we will run tests for 2 weeks.

Results

The results can be viewed in the 'log' section at the bottom of the Line page. A 'pin' will also be added to the CQM graph when the test is run.

An example End to End test results:

BT Test E2E Access Test/DCN:Inconclusive OR test pass. Unable to find the fault.
Down:40.0 (39.9/39.7/39.9) Up:10.0 (10.0/10.0/10.0)
NA 0.128M-40M Downstream, Interleaving Off - 0.128M-10M Upstream, Interleaving Off
In Sync Pass:GTC_FTTC_SERVICE_0000 GEA service test completed and no fault found