L2TP from Customers to AAISP
There are two reasons to use L2TP to connect in to AAISP:
- As a back up for your existing AAISP circuit in the even of a fault, using L2TP you can use another ISP to connect in to AAISP and have your normal IP addresses etc whilst your AAISP connection is fixed. Ask staff to set this up.
- Connect in to AAISP over a third-party internet connection. This gives you your an AAISP IPv4 address and an IPv6 block.
- Endpoint: l2tp.aa.net.uk
- Username & Password as supplied
- Hostname: AAISP
- Plain L2TP without any IPsec, MSCHAPv2 authentication
You may have to set a lower MTU to accommodate the host ISP, possible as low as 1462 (or lower for some ISPs). In theory fragments will work to allow 1500 MTU on our service, but fragments are inefficient, and if everyone sends fragmented packets that could degrade the service.
Some Notes from customers setting up L2TP IN to AAISP:
Creating a L2TP connection from a FireBrick to AAISP)
Creating a L2TP connection from Apple OSX to AAISP
Creating a L2TP connection from Windows to AAISP
Creating a L2TP connection from Linux to AAISP
Creating a L2TP connection from Routerboard to AAISP
Creating a L2TP connection from OpenWRT to AAISP
Creating a L2TP connection from Cisco to AAISP
Creating a L2TP connection from other routers to AAISP
Pages in category "Incoming L2TP"
The following 13 pages are in this category, out of 13 total.