L2TP from Customers to AAISP
There are two reasons to use L2TP to connect in to AAISP:
- As a backup for your existing AAISP circuit in the event of a fault.
- Logging in over L2TP using your DSL credentials (ie firstname.lastname@example.org) from a different ISP will then give you your normal IP addresses etc whilst your AAISP connection is being fixed.
- Connect in to AAISP over a third-party internet connection. This gives you your an AAISP IPv4 address and an IPv6 block. There are more reasons and information on http://aa.net.uk/broadband-l2tp.html
For L2TP as a backup please contact sales staff, for a separate L2TP connection please order via http://aa.net.uk/broadband-l2tp.html
- Endpoint: l2tp.aa.net.uk
- Username & Password as supplied
- Hostname: AAISP
- Plain L2TP without any IPsec, MSCHAPv2 authentication
You may have to set a lower MTU to accommodate the host ISP, possible as low as 1462 (or lower for some ISPs). In theory fragments will work to allow 1500 MTU on our service, but fragments are inefficient, and if everyone sends fragmented packets that could degrade the service.
Some Notes from customers setting up L2TP IN to AAISP:
Creating a L2TP connection from a FireBrick to AAISP)
Creating a L2TP connection from Apple OSX to AAISP
Creating a L2TP connection from Windows to AAISP
Creating a L2TP connection from Linux to AAISP
Creating a L2TP connection from Routerboard to AAISP
Creating a L2TP connection from OpenWRT to AAISP
Creating a L2TP connection from Cisco to AAISP
Creating a L2TP connection from other routers to AAISP
Pages in category "Incoming L2TP"
The following 14 pages are in this category, out of 14 total.
- L2TP Client: Cisco
- L2TP Client: FireBrick
- L2TP Client: Linux
- L2TP Client: Mobile Broadband Routers
- L2TP Client: OpenWRT
- L2TP Client: OSX
- L2TP Client: Other Routers
- L2TP Client: pfSense
- L2TP Client: Routerboard
- L2TP Client: SNOM
- L2TP Client: Ubiquiti Edgerouter
- L2TP Client: Windows
- L2TP Latency Speed Tweaks
- L2TP Starlink