Category:Technicolor DGA0122: Difference between revisions

From AAISP Support Site
Line 17: Line 17:
*ADSL1, ADSL2+
*ADSL1, ADSL2+
*VDSL (FTTC)
*VDSL (FTTC)
*''G.Fast'' - using the Ethernet WAN port connected to an existing G.FAST modem
*''G.Fast'' - using the Ethernet WAN port connected '''to an existing G.FAST modem'''
*''FTTP, FTTPoD'' - using the Ethernet WAN port to the fibre termination 'modem'
*''FTTP, FTTPoD'' - using the Ethernet WAN port '''to the fibre termination 'modem''''


==Factory Default Admin Username/Password==
==Factory Default Admin Username/Password==

Revision as of 17:12, 8 December 2020


Technicolor DGA0122
Technicolor DGA0122


Basic Specs

  • 4x 10/100M/1,000M ports.
  • Modem supports VDSL (FTTC) and ADSL/ADSL2+ (Not G.Fast)
  • WiFi is:
    • 2.4GHz WiFi-4, (2x2) IEEE 802.11n
    • 5GHz, WiFi-5, (3x3) IEEE 802.11ac
  • 2 FXS ports, for connecting an analogue phone to a VoIP account
  • MTU 1500 when in bridge mode not possible.
  • File:DGA0122 v1.2 public.pdf

Suitable for:

  • ADSL1, ADSL2+
  • VDSL (FTTC)
  • G.Fast - using the Ethernet WAN port connected to an existing G.FAST modem
  • FTTP, FTTPoD - using the Ethernet WAN port to the fibre termination 'modem'

Factory Default Admin Username/Password

Default/Factory Password
IP: 192.168.1.1 (will change once configured if you have a block of IPv4 addresses)
Username: admin (or engineer for some superpowers)
Password: Before configured it will be as stated on the rear panel. Once configured it will be the one printed on the A&A card.
WiFi Password: Before configured it will be as stated on the rear panel as 'ACCESS KEY'. Once configured it will be the one printed on the A&A card.


Bugs and workarounds

We've identified a couple of bugs and have listed them here:

Media in category 'Technicolor DGA0122'

The following 9 files are in this category, out of 9 total.