Debian IPv6 Tunnel Config: Difference between revisions
No edit summary |
mNo edit summary |
||
| (5 intermediate revisions by 2 users not shown) | |||
| Line 4: | Line 4: | ||
Configuring your etch host then requires you just to edit /etc/network/interfaces and add the following stanza at the end: |
Configuring your etch host then requires you just to edit /etc/network/interfaces and add the following stanza at the end: |
||
auto 6in4 |
|||
iface 6in4 inet6 v4tunnel |
|||
address 2001:08B0:XXXX:0001::1 |
|||
| ⚫ | |||
| ⚫ | |||
ttl 64 |
|||
up ip link set mtu 1280 dev 6in4 |
|||
up ip route add default via 2001:08B0:XXXX:0001::2 dev 6in4 |
|||
remembering to change the XXXX to whatever value you've been allocated. |
remembering to change the XXXX to whatever value you've been allocated. |
||
After that just type "ifup 6in4" (as root) and your link should be up. |
After that just type "ifup 6in4" (as root) and your link should be up. |
||
This could be it !! : |
This could be it !! : |
||
<pre> |
|||
auto 6in4 |
|||
iface 6in4 inet6 v4tunnel |
|||
address 2001:8b0:XXXX::1 |
address 2001:8b0:XXXX::1 |
||
| ⚫ | |||
local <ppp0 IPv4 IP> |
|||
endpoint 81.187.81.6 |
endpoint 81.187.81.6 |
||
| ⚫ | |||
ttl 64 |
|||
</pre> |
|||
[[Category:3rd Party Routers]] |
|||
Latest revision as of 09:16, 25 February 2015
Draft in progress .....
Configuring your etch host then requires you just to edit /etc/network/interfaces and add the following stanza at the end:
remembering to change the XXXX to whatever value you've been allocated.
After that just type "ifup 6in4" (as root) and your link should be up.
This could be it !! :
auto 6in4
iface 6in4 inet6 v4tunnel
address 2001:8b0:XXXX::1
netmask 48
endpoint 81.187.81.6
gateway ::81.187.81.6