Difference between revisions of "Debian IPv6 Tunnel Config"

From AAISP Support Site
Jump to: navigation, search
[unchecked revision][unchecked revision]
Line 4: Line 4:
 
Configuring your etch host then requires you just to edit /etc/network/interfaces and add the following stanza at the end:
 
Configuring your etch host then requires you just to edit /etc/network/interfaces and add the following stanza at the end:
   
auto 6in4
 
iface 6in4 inet6 v4tunnel
 
address 2001:08B0:XXXX:0001::1
 
netmask 124
 
endpoint 81.187.81.6
 
ttl 64
 
up ip link set mtu 1280 dev 6in4
 
up ip route add default via 2001:08B0:XXXX:0001::2 dev 6in4
 
   
 
remembering to change the XXXX to whatever value you've been allocated.
 
remembering to change the XXXX to whatever value you've been allocated.
   
 
After that just type "ifup 6in4" (as root) and your link should be up.
 
After that just type "ifup 6in4" (as root) and your link should be up.
 
   
   
Line 27: Line 18:
 
endpoint 81.187.81.6
 
endpoint 81.187.81.6
 
ttl 64
 
ttl 64
  +
up ip route add default dev 6in4

Revision as of 14:33, 16 February 2011

Draft in progress .....


Configuring your etch host then requires you just to edit /etc/network/interfaces and add the following stanza at the end:


remembering to change the XXXX to whatever value you've been allocated.

After that just type "ifup 6in4" (as root) and your link should be up.


This could be it !! :

 auto 6in4
 iface 6in4 inet6 v4tunnel
   address 2001:8b0:XXXX::1      
   local <ppp0 IPv4 IP>     
   endpoint 81.187.81.6
   ttl 64
   up ip route add default  dev 6in4