FireBrick SIP Configuration

From AAISP Support Site

Also see: FireBrick VoIP Page which has more details about the feature.

Taking an example of a single SIP account with AAISP, and a couple of SIP phones, a FireBrick can be configured as follows.

We'll set this up so that incoming calls route to a 'ring group', which in turn will route to a number of internal extensions. Outgoing calls from the local phones will all go out via the single SIP account with the service provider.

Go to Config - Edit - Setup - Edit VoIP config.

Add a carrier

This is the SIP account that you're connecting to:

name AASIP
Comment Main Office Number
username

SIP account name (Phone number)

password SIP account password
registrar SIP Registrar server: registrar.aasip.co.uk
proxy SIP Proxy server, proxy.aasip.co.uk
extn Internal extension number to call for incoming calls, 100
allow IPs that are allowed to talk SIP to us (ie providers IPs), 81.187.30.110-119
display-name Name shown on phones, Office}

Click Save. then if you go to Status - VoIP, you should see the Carrier listed with an expiry - this shows that the FireBrick is registered to the server

Next create some users:

Config - Edit - Setup - Edit VoIP config These will be your local SIP user accounts that your telephones use to register against the FireBrick with. Add new VoIP user:

name John
display-name John
username john
password *******
allow IPs that are allowed to register, put in your LAN ip addresses, eg, x.x.x.x/27
ddi The full number for this user, ie same as the carrier's number assigned to you.
extn John's internal extension number, eg 101
carrier Pick AASIP, this will be the carrier John uses to dial out on
max-calls 1, if you just want to make 1 call at a time with this account

Click save