IPsec Firewall: Difference between revisions

Back up to the FireBrick IPsec Tunnels Category Page
From AAISP Support Site
(lang=xml)
(→‎top: clean up)
 
Line 1: Line 1:
<indicator name="Tunnels">[[File:Menu-IPsec.svg|link=:Category:FireBrick_IPsec|30px|Back up to the FireBrick IPsec Tunnels Category Page]]</indicator>
<indicator name="Tunnels">[[File:Menu-IPsec.svg|link=:Category:FireBrick IPsec|30px|Back up to the FireBrick IPsec Tunnels Category Page]]</indicator>
If there is no NAT involved, you need:
If there is no NAT involved, you need:
*UDP port 500 for the IKE control channel
*UDP port 500 for the IKE control channel
Line 38: Line 38:
</syntaxhighlight>
</syntaxhighlight>


[[Category:FireBrick_IPsec|Firewall]]
[[Category:FireBrick IPsec|Firewall]]

Latest revision as of 23:59, 17 August 2018

If there is no NAT involved, you need:

  • UDP port 500 for the IKE control channel
  • IP protocol ESP (50) for the data channel.

Example:

   <rule-set name="IPsec" source-interface="pppoe" target-interface="self" no-match-action="continue" comment="Non-NATed IPsec connections from PPP to the Brick">
      <rule name="IKE" target-port="500" protocol="17" action="accept" comment="Internet Key Exchange"/>
      <rule name="ESP" protocol="50" action="accept" comment="Encapsulating Security Payload - encryption protocol"/>
   </rule-set>

However, more likely if your devices are out on the road:

If NAT has been detected, or you force IKE to believe NAT is present (see below) you need:

  • UDP port 4500 (IKE)
  • (no need for protocol ESP).
  • You may need UDP port 500 too, to allow the initial contact to be made - though as soon as NAT is detected (or it has been forced) IKE switches to 4500.

The config force-NAT option [Note the capitalisation ] can be used to force IKE to treat the connection as if it was NATed. This is in the top-level ipsec-ike config item and you need "Show all" on the UI.

Example:

   <rule-set name="IPsec" source-interface="pppoe" target-interface="self" no-match-action="continue" comment="Allow NATed IPsec connections from PPP to the Brick">
      <rule name="IKE" target-port="500 4500" protocol="17" action="accept" comment="Internet Key Exchange"/>
   </rule-set>

You can join the two rules to create a set that will work for NAT and Non-NAT:

Example:

   <rule-set name="IPsec" source-interface="pppoe" target-interface="self" no-match-action="continue" comment="Allow NATed and Non-NATed IPsec connections from PPP to the Brick">
      <rule name="IKE" target-port="500 4500" protocol="17" action="accept" comment="Internet Key Exchange"/>
      <rule name="ESP" protocol="50" action="accept" comment="Encapsulating Security Payload - encryption protocol"/>
   </rule-set>