Jump to content

This is the support site for Andrews & Arnold Ltd, a UK Internet provider. Information on these pages is generally for our customers but may be useful to others, enjoy!

IPv6 Configuration: Difference between revisions

clean up
(clean up)
(23 intermediate revisions by 9 users not shown)
= Related Pages on the A&A Website: =
 
*[http://www.aaisp.net.uk/kb-broadband-ipv6.html www.aaisp.net.uk/kb-broadband-ipv6.html]
*[http://www.pitt-pladdy.com/blog/_20100123-184109%2B0000%20OpenWrt%20with%20native%20IPv6%20on%20DG834%20v2%20%28using%20AAISP%29/ Using OpenWRT as an IPv6 router]
*[http://wiki.openwrt.org/doc/howto/ipv6 Configuring OpenWRT for IPv6]
*[http://www.davidc.net/networking/ipv6-source-address-selection-linux IPv6 Source Address Selection on Linux]
*[http://ipv6.raphnet.net/ Linux/BSD Configuration commands]
 
== ConsumerIPv6 CPEready Equipmenthardware ==
 
The following equipment has been successfully used as an IPv6 Router for home use. These are known as CPE or Customer Premises Equipment.
 
*Linksys NSLU2 running OpenWRT 10.03 (Backfire) with a Netgear DM111P ADSL2+ DSL Modem
*Linksys NSLU2 running Debian Squeeze with a SpeedTouch USB ADSL modem [[IPv6 SpeedTouch|Guide]]
*Netgear DG834v2 running OpenWRT 8.09 (Kamikaze)
*Linksys WRTU54G-TM running OpenWRT trunk build with a Netgear DM111P Modem
*Netgear WNR854T running OpenWRT 10.03 (Backfire) with BT Openreach modem on FTTC
*[[Router - Cisco IPv6 IOS Versions|Cisco Devices]] running 12.4 and above
*Our [[FireBrick 2700]] page has info on Native IPv6 config (also applies to 2500)
*[[Vigor 120]] - earlier firmware versions have problems with IPv6
*Billion BiPAC 7800N with firmware 1.06d
*The MikroTik [[RouterOS]] page has information on IPv6 configuration
The search for additional IPv6 CPE possibilities: [[IPv6CPESearch]]
* [[Router - Juniper SRX|Juniper SRX]] series of routers
 
== Native IPv6 Connections ==
 
*[[Cisco IPv6 Native Config]]
*[[IPv6]] - How AAISP manage IPv6 on Broadband lines.
 
== IPv6 over IP Tunnelled Connections ==
*[[Cisco IPv6 Tunnel Config]]
*[[FreeBSD IPv6 Tunnel Config]]
*[[FireBrick 2700 v6 Tunnel]]
*[[Debian IPv6 Tunnel Config]]
*[[Linux NetworkManager IPv6 Tunnel Config]]
 
See also the configuration examples on the IPv6 Knowledge-base page referenced above.
[[Category:IPv6]] [[Category:Configuring]]
 
== FireBrick 2500/2700 ==
 
It's quite easy....
It's quite easy.... Assuming you have an IPv6 block allocated to your line on Clueless and you're using the FB for PPPoE, then all the FB config needs is:
 
An IPv6 address on the LAN subnet
ra="true"*An inIPv6 address on the LAN subnet
*ra="true" in the subnet
editor
698

edits