IPv6 Configuration: Difference between revisions

From AAISP Support Site
Line 8: Line 8:
*[http://wiki.openwrt.org/doc/howto/ipv6 Configuring OpenWRT for IPv6]
*[http://wiki.openwrt.org/doc/howto/ipv6 Configuring OpenWRT for IPv6]
*[http://www.davidc.net/networking/ipv6-source-address-selection-linux IPv6 Source Address Selection on Linux]
*[http://www.davidc.net/networking/ipv6-source-address-selection-linux IPv6 Source Address Selection on Linux]
*[http://ipv6.raphnet.net/ Linux/BSD Configuration commands]


== IPv6 ready hardware ==
== IPv6 ready hardware ==

Revision as of 13:49, 1 February 2011

Related Pages on the A&A Website:

Useful Blog/HOWTO Entries

IPv6 ready hardware

The following equipment has been successfully used as an IPv6 Router for home use. These are known as CPE or Customer Premises Equipment.

  • Linksys NSLU2 running OpenWRT 10.03 (Backfire) with a Netgear DM111P ADSL2+ DSL Modem
  • Linksys NSLU2 running Debian Squeeze with a SpeedTouch USB ADSL modem Guide
  • Netgear DG834v2 running OpenWRT 8.09 (Kamikaze)
  • Our FireBrick 2700 page has info on Native IPv6 config (also applies to 2500)

The search for additional IPv6 CPE possibilities: IPv6CPESearch

IPv6 over IP Tunnelled Connections

See also the configuration examples on the IPv6 Knowledge-base page referenced above.

FireBrick 2500/2700

It's quite easy.... Assuming you have an IPv6 block allocated to your line on Clueless and you're using the FB for PPPoE, then all the FB config needs is:

  • An IPv6 address on the LAN subnet
  • ra="true" in the subnet