This is the support site for Andrews & Arnold Ltd, a UK Internet provider. Information on these pages is generally for our customers but may be useful to others, enjoy!

Difference between revisions of "IPv6 Configuration"

From AAISP Support Site
Jump to navigation Jump to search
[unchecked revision][unchecked revision]
Line 31: Line 31:
 
*[[FreeBSD IPv6 Tunnel Config]]
 
*[[FreeBSD IPv6 Tunnel Config]]
 
*[[FireBrick 2700 v6 Tunnel]]
 
*[[FireBrick 2700 v6 Tunnel]]
  +
*[[Debian IPv6 Tunnel Config]]
   
 
See also the configuration examples on the IPv6 Knowledge-base page referenced above.
 
See also the configuration examples on the IPv6 Knowledge-base page referenced above.

Revision as of 14:00, 16 February 2011

Related Pages on the A&A Website:

Useful Blog/HOWTO Entries

IPv6 ready hardware

The following equipment has been successfully used as an IPv6 Router for home use. These are known as CPE or Customer Premises Equipment.

  • Linksys NSLU2 running OpenWRT 10.03 (Backfire) with a Netgear DM111P ADSL2+ DSL Modem
  • Linksys NSLU2 running Debian Squeeze with a SpeedTouch USB ADSL modem Guide
  • Netgear DG834v2 running OpenWRT 8.09 (Kamikaze)
  • Cisco devices running 12.4 and above
  • Our FireBrick 2700 page has info on Native IPv6 config (also applies to 2500)
  • Vigor 120 - earlier firmware versions have problems with IPv6

The search for additional IPv6 CPE possibilities: IPv6CPESearch

Native IPv6 Connections

IPv6 over IP Tunnelled Connections

See also the configuration examples on the IPv6 Knowledge-base page referenced above.

FireBrick 2500/2700

It's quite easy.... Assuming you have an IPv6 block allocated to your line on Clueless and you're using the FB for PPPoE, then all the FB config needs is:

  • An IPv6 address on the LAN subnet
  • ra="true" in the subnet