This is the support site for Andrews & Arnold Ltd, a UK Internet provider. Information on these pages is generally for our customers but may be useful to others, enjoy!
Related Pages on the A&A Website:
Useful Blog/HOWTO Entries
- Using OpenWRT as an IPv6 router
- Configuring OpenWRT for IPv6
- IPv6 Source Address Selection on Linux
- Linux/BSD Configuration commands
IPv6 ready hardware
The following equipment has been successfully used as an IPv6 Router for home use. These are known as CPE or Customer Premises Equipment.
- Linksys NSLU2 running OpenWRT 10.03 (Backfire) with a Netgear DM111P ADSL2+ DSL Modem
- Linksys NSLU2 running Debian Squeeze with a SpeedTouch USB ADSL modem Guide
- Netgear DG834v2 running OpenWRT 8.09 (Kamikaze)
- Cisco devices running 12.4 and above
- Our FireBrick 2700 page has info on Native IPv6 config (also applies to 2500)
- Vigor 120 - earlier firmware versions have problems with IPv6
The search for additional IPv6 CPE possibilities: IPv6CPESearch
Native IPv6 Connections
IPv6 over IP Tunnelled Connections
See also the configuration examples on the IPv6 Knowledge-base page referenced above.
It's quite easy.... Assuming you have an IPv6 block allocated to your line on Clueless and you're using the FB for PPPoE, then all the FB config needs is:
- An IPv6 address on the LAN subnet
- ra="true" in the subnet