L2TP Client: Linux: Difference between revisions

Back up to the Incoming L2TP Category
From AAISP Support Site
(→‎top: clean up)
(Updated with a little troubleshooting info)
Line 30: Line 30:
</ol>
</ol>
This should give you a new PPP device which encapsulates the L2TP connection.
This should give you a new PPP device which encapsulates the L2TP connection.

== Troubleshooting ==
Logs are written /var/log/daemon.log
If you see "No such tunnel", you might want to try restarting the daemon

Revision as of 10:51, 9 April 2020

Linux / xl2tpd

  1. Ensure the following kernel options are set or the corresponding modules are available:
    1. CONFIG_PPPOL2TP
    2. CONFIG_L2TP
  2. Install xl2tpd and pppd on your Linux router.
  3. Edit /etc/xl2tpd/xl2tpd.conf to contain the following:
    [lac aaisp]
    lns = l2tp.aaisp.net.uk
    require authentication = no
    pppoptfile = /etc/ppp/options.aaisp
  4. Create /etc/ppp/options.aaisp containing the following (obviously change the name and password to match your L2TP login details):
    +ipv6
    ipv6cp-use-ipaddr
    name xyz@a.X
    password Your_xyz@A.X_password
    noauth
  5. Create the xl2tpd control file:
    mkdir -p /var/run/xl2tpd
    touch /var/run/xl2tpd/l2tp-control
  6. Start the xl2tpd service (for systemd, use service command for older RC systems):
    systemctl start xl2tpd
  7. Tell the daemon to connect to aaisp:
    echo "c aaisp" > /var/run/xl2tpd/l2tp-control

This should give you a new PPP device which encapsulates the L2TP connection.

Troubleshooting

Logs are written /var/log/daemon.log If you see "No such tunnel", you might want to try restarting the daemon