L2TP Client: Windows: Difference between revisions

Back up to the Incoming L2TP Category
From AAISP Support Site
(Add Windows 10 notes)
m (Reword)
Line 16: Line 16:
SC START RASMAN
SC START RASMAN


Also, once the connection has been created:
Also, once the connection has been created, ensure CHAP authentication is enabled:


# Network and Sharing Centre
# Open Network and Sharing Centre
# Change adapter settings
# Click Change adapter settings
# Find the L2TP connection
# Find the L2TP connection, it will have whatever name you gave it
# Right click and choose Properties
# Right click the connection and choose Properties
# Go to the Security Tab
# Go to the Security Tab
# In the 'Authentication' section
# Find the 'Authentication' section
# Select 'Allow these protocols'
# Select the 'Allow these protocols' radio button
# Ensure 'Challenge Handshake Authentication Protocol (CHAP)' is enabled.
# Ensure 'Challenge Handshake Authentication Protocol (CHAP)' is checked.

Revision as of 22:21, 30 September 2016

Windows 7

Connecting with Windows 7 was almost as easy except that the default connection settings don't work. You have to edit the connection properties and on the Security tab change 'Type of VPN:' to 'Layer 2 Tunneling Protocol with IPsec (L2TP/IPSec)' otherwise it only tries PPTP, and change 'Data encryption:' to 'Optional encryption (connect even if no encryption)' as it doesn't like A+A's certificate (because RevK declines to use a root certification authority recognised by Microsoft, or is it that Microsoft declines to recognise the root certification authority chosen by RevK). I guess the alternative would probably be to add the root certificate to the machine in question. Anyway, with those two changes it works fine.

Watch out if you are using IPv6. It seems that Win7 negotiates a non-routable IPv6 address with the LNS. You have to discard this address and manually configure one of your routed IPv6 addresses. ipconfig /release6 is your friend here.

Windows 10

Windows 10 seems very keen on using IPsec with L2TP. To turn this off, in an Administrator Command Prompt do:

   SC STOP RASMAN    ; you may have to wait a bit for this to stop
   SC QUERY RASMAN   ; ensure it is STOPPED
   REG ADD HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\Rasman\Parameters /v ProhibitIpSec /t REG_DWORD /d 1 /f
   SC START RASMAN

Also, once the connection has been created, ensure CHAP authentication is enabled:

  1. Open Network and Sharing Centre
  2. Click Change adapter settings
  3. Find the L2TP connection, it will have whatever name you gave it
  4. Right click the connection and choose Properties
  5. Go to the Security Tab
  6. Find the 'Authentication' section
  7. Select the 'Allow these protocols' radio button
  8. Ensure 'Challenge Handshake Authentication Protocol (CHAP)' is checked.