VoIP Phones - Grandstream HT8xx: Difference between revisions

Back up to the VoIP Configuring page
From AAISP Support Site
(Mention the whitelist and blacklist for config access)
(Show steps for whitelist and blacklist)
Line 28: Line 28:
*You will also want to set up firewall rules, as per the [[VoIP Firewall]] page.
*You will also want to set up firewall rules, as per the [[VoIP Firewall]] page.
*Also see the [[VoIP Security]] page for information about securing your VoIP service.
*Also see the [[VoIP Security]] page for information about securing your VoIP service.
*You can have an IP address whitelist and blacklist for web, telnet, and ssh access to the ATA. Unfortunately it only accepts IPv4 address ranges.
*You can have an IP address whitelist and blacklist for web, telnet, and ssh access to the ATA. Unfortunately it only accepts IPv4 address ranges. ''Basic Settings'', ''Web/SSH Access'', ''White List for WAN Side'', similar for blacklist.

[[Category:VoIP Phones|Grandstream]]
[[Category:VoIP Phones|Grandstream]]

Revision as of 14:17, 11 October 2018

Grandstream HT801.png


Feature Notes
Supports 302 Redirect ?
Tested on FireBrick SIP Server No
IPv6 Support Yes

This is based on the author's experience of the HT801 (bought new in Sep 2018), which is a small unit which provides 1 FXS port and no FXO ports. It does IPv6. Similar units are the HT802 (which has 2 FXS ports), and the HT81x series (which adds a NAT router, and is available with different numbers of FXS ports).

  • Basic Settings, Internet Protocol, select Both, prefer IPv6 (or, if you're brave, select IPv6 Only)
  • See https://www.ukvoipforums.com/viewtopic.php?t=1061 for UK settings (although you might want to set the NTP Server to time.aa.net.uk as that has IPv6 addresses)
  • Can support pulse dialling handsets - FXS Port, Enable Pulse Dialing, select Yes
  • Can send BT CLID to handsets, see UK settings link above

Firewall & Security

  • You will also want to set up firewall rules, as per the VoIP Firewall page.
  • Also see the VoIP Security page for information about securing your VoIP service.
  • You can have an IP address whitelist and blacklist for web, telnet, and ssh access to the ATA. Unfortunately it only accepts IPv4 address ranges. Basic Settings, Web/SSH Access, White List for WAN Side, similar for blacklist.