ZyXEL Port Forwarding: Difference between revisions

From AAISP Support Site
mNo edit summary
Line 3: Line 3:
portmap (port map) or port forwarding on a VMG1312
portmap (port map) or port forwarding on a VMG1312


=== This has been tested to work with firmware ver. V1.00(AAJZ.5)C0). ===
== This has been tested to work with firmware ver. V1.00(AAJZ.5)C0). ==


# Log in to router
# Log in to router
Line 13: Line 13:
[[File:3.png]]
[[File:3.png]]


# Go to Network Setting > NAT. Set a name. WAN interface dropdown should be set based on the type of service i.e: AAISP-ADSL for ADSL or AAISP-VDSL for VDSL. WAN IP should be the WAN IP (of course), server address will be the address you'd like to forward to (same as destination IP in the previous menu). Trigger start port, end port, translation start port, and translation end port need to be set to the port you're looking to forward. Protocol should be set as required.
# Go to Network Setting > NAT. Set a name. WAN interface dropdown should be set based on the type of service i.e.: AAISP-ADSL for ADSL or AAISP-VDSL for VDSL. WAN IP should be the WAN IP (of course), server address will be the address you'd like to forward to (same as destination IP in the previous menu). Trigger start port, end port, translation start port, and translation end port need to be set to the port you're looking to forward. Protocol should be set as required.


[[File:4.png]]
[[File:4.png]]

Revision as of 00:08, 15 March 2017


portmap (port map) or port forwarding on a VMG1312

This has been tested to work with firmware ver. V1.00(AAJZ.5)C0).

  1. Log in to router
  1. Security > Firewall > 'Access Control' tab
  1. Add a new ACL rule. Set a name, destination IP will be the WAN IP, set protocol as required, set destination port to the port you'd like to forward. All the other settings should be OK. Do this again for any other rules you'd like to make.

3.png

  1. Go to Network Setting > NAT. Set a name. WAN interface dropdown should be set based on the type of service i.e.: AAISP-ADSL for ADSL or AAISP-VDSL for VDSL. WAN IP should be the WAN IP (of course), server address will be the address you'd like to forward to (same as destination IP in the previous menu). Trigger start port, end port, translation start port, and translation end port need to be set to the port you're looking to forward. Protocol should be set as required.

4.png