editor
699
edits
This is the support site for Andrews & Arnold Ltd, a UK Internet provider. Information on these pages is generally for our customers but may be useful to others, enjoy!
No edit summary |
(→top: clean up) |
||
(12 intermediate revisions by 3 users not shown) | |||
[[Image:T582-small.png|link=:Category:
It may be possible to configure the router so that it acts as a bridge and not a router.
We would recommend a [[Router - ZyXEL P660R-D1|ZyXEL P660-D1]] or a [[Router - DLINK 320B|Dlink]] if you are looking for a bridge device, this are available to purchase from Sales.
We cannot support this if you break it, sorry.
==Method One (config file)==
Notes from the customer:
''It doesn't seem possible to make it work without two internet
connections being configured, even though 'Internet2' is disconnected.
I removed it's config and restored, and the [[ethernet]] ports didn't want
to come up!''
''I essentially took a config I found for the BE 'bebox' and merged
sections with the default config that come with the router. I am sure
it could be made cleaner, and it could be possible to rid the
'Internet2' and still have it work.''
'''Config file:''' [[File:AA_TG582n_Bridge_config.ini.zip.zip]]
==Method Two (Manual configuration steps)==
Another Customer entry:
To put the router into proper bridge mode, telnet in and enter these commands
:ppp relay flush
[[Category:Router TG582N]]▼
:ppp flush
:eth flush
:atm flush
:atm phonebook flush
:saveall
:atm phonebook add name=BrPPPoE_ph addr=0.38
:atm ifadd intf=BrPPPoE_atm
:atm ifconfig intf=BrPPPoE_atm dest=BrPPPoE_ph encaps=vcmux ulp=mac
:atm ifattach intf=BrPPPoE_atm
:eth bridge ifadd intf=BrPPPoE_br
:eth bridge ifconfig intf=BrPPPoE_br dest=BrPPPoE_atm
:eth bridge ifattach intf=BrPPPoE_br
:service system modify name=DHCP-S state=disabled
:wireless radio state=disabled
:saveall
[[IPv6|IPV6]] not tested with the above setup although, in theory, it should work as all the above is, is a clean bridging setup. (it does work, but not immediately it seems)
I have recently migrated from BE and their router had a 'half-bridge' mode where the router would only use the dhcp allocated WAN IP address and route the allocated subnet onwards.
I am investigating this setup on the [[TG582N]]. Main advantage is that you can then still easily access the router.
▲[[Category:Router TG582N|Bridge]]
|