Changes

Jump to: navigation, search

IPv6 Configuration

1,944 bytes added, 00:00, 18 August 2018
clean up
= Related Pages on the A&A Website:= =
 
*[http://www.aaisp.net.uk/kb-broadband-ipv6.html www.aaisp.net.uk/kb-broadband-ipv6.html]
 
== IPv6 over IP Tunnelled Connections ==
== Useful Blog/HOWTO Entries ==
* [[Cisco IPv6 Tunnel Config]]
 
* [[FreeBSD IPv6 Tunnel Config]]
*[http://www.pitt-pladdy.com/blog/_20100123-184109%2B0000%20OpenWrt%20with%20native%20IPv6%20on%20DG834%20v2%20%28using%20AAISP%29/ Using OpenWRT as an IPv6 router]
See also the configuration examples on the IPv6 Knowledge-base page referenced above.
*[http://wiki.openwrt.org/doc/howto/ipv6 Configuring OpenWRT for IPv6]
*[http://www.davidc.net/networking/ipv6-source-address-selection-linux IPv6 Source Address Selection on Linux]
*[http://ipv6.raphnet.net/ Linux/BSD Configuration commands]
 
== IPv6 ready hardware ==
 
The following equipment has been successfully used as an IPv6 Router for home use. These are known as CPE or Customer Premises Equipment.
 
*Linksys NSLU2 running OpenWRT 10.03 (Backfire) with a Netgear DM111P ADSL2+ DSL Modem
*Linksys NSLU2 running Debian Squeeze with a SpeedTouch USB ADSL modem [[IPv6 SpeedTouch|Guide]]
*Netgear DG834v2 running OpenWRT 8.09 (Kamikaze)
*Linksys WRTU54G-TM running OpenWRT trunk build with a Netgear DM111P Modem
*Netgear WNR854T running OpenWRT 10.03 (Backfire) with BT Openreach modem on FTTC
*[[Router - Cisco IPv6 IOS Versions|Cisco Devices]] running 12.4 and above
*Our [[FireBrick 2700]] page has info on Native IPv6 config (also applies to 2500)
*[[Vigor 120]] - earlier firmware versions have problems with IPv6
*Billion BiPAC 7800N with firmware 1.06d
*The MikroTik [[RouterOS]] page has information on IPv6 configuration
The search for additional IPv6 CPE possibilities: [[IPv6CPESearch]]
* [[Router - Juniper SRX|Juniper SRX]] series of routers
 
== Native IPv6 over IP Tunnelled Connections ==
 
* [[Cisco IPv6 TunnelNative Config]]
*[[IPv6]] - How AAISP manage IPv6 on Broadband lines.
 
== IPv6 over IP Tunnelled Connections ==
 
*[[Cisco IPv6 Tunnel Config]]
* [[FreeBSD IPv6 Tunnel Config]]
*[[FireBrick 2700 v6 Tunnel]]
*[[Debian IPv6 Tunnel Config]]
*[[Linux NetworkManager IPv6 Tunnel Config]]
 
See also the configuration examples on the IPv6 Knowledge-base page referenced above.
 
[[Category:IPv6]] [[Category:Configuring]]
 
== FireBrick 2500/2700 ==
 
It's quite easy.... Assuming you have an IPv6 block allocated to your line on Clueless and you're using the FB for PPPoE, then all the FB config needs is:
 
*An IPv6 address on the LAN subnet
*ra="true" in the subnet
530
edits

Navigation menu