|
= Other Settings & Config info =
==IP Type Settings ==
=== Manually adjust DHCP range ===
You can't delete the default DHCP range from the web GUI. You need to use the CLI!
"dhcp server flush" removes all existing DHCP settings. In this example 81.187.X.Z is the router's LAN address.
dhcp server flush
dhcp server config state=enabled
dhcp server pool add name=LAN index=0
dhcp server pool config name=LAN intf=LocalNetwork poolstart=81.187.X.X poolend=81.187.X.Y netmask=28 gateway=81.187.X.Z server=81.187.X.Z primdns=217.169.20.20 secdns=217.169.20.21
saveall
dhcp server pool list
"dhcp server pool list" should be used to check whether it is set up correctly or not.
=== Disabling Router Advertisements (RA rt6advd) ===
Telnet in and:
To display the inferface(s) that RA is on:
ip rt6advd iflist
Shows something like:
Flags Legend: [A]ttached [M]anaged [O]ther - Def. Rtr. Pref. [L]ow / Medi[U]m / [H]igh
Interface AdvInterval Lifetime Reachable Retrans. CurHopLimit LinkMTU Flags NextRA
---------------- ----------- -------- ---------- ---------- ----------- ------- ------ --------
LocalNetwork 200 / 600 1800 0 0 64 0 [A.OU] 249
To remove it:
ip rt6advd ifdelete
And then to a iflist again to check, and LocalNetwork should be gone.
=== Adding Static-routes ===
ip rtlist
ip rtadd dst=network/mask gateway=gatewayip
ip saveall
=== Enabling/Disabling NAT ===
To view NAT status:
nat iflist
If required, rather than going through the config wizard on the web interface, you can enable/disable NAT on the telnet interface by:
nat ifconfig intf Internet translation enabled
or
nat ifconfig intf Internet translation disabled
You may then need to:
saveall
===Mixing NAT and Public addresses===
[[Mixed NAT]] explains how to configure the router so that you can have NAT clients and clients with public addresses at the same time.
== Firewall & Security Related==
| 