CityFibre ONT: Difference between revisions
m (→LEDs) |
|||
| Line 8: | Line 8: | ||
=LEDs= |
=LEDs= |
||
==Overview== |
===Overview=== |
||
There are four LEDs on the CityFibre ONT: |
There are four LEDs on the CityFibre ONT: |
||
| Line 16: | Line 16: | ||
*LED 4 (Right) - Ethernet |
*LED 4 (Right) - Ethernet |
||
==Normal state of the LEDs == |
===Normal state of the LEDs === |
||
When working properly this is the state each light should be in, indicating a good connection/service: |
When working properly this is the state each light should be in, indicating a good connection/service: |
||
Revision as of 20:15, 1 August 2022
LEDs
Overview
There are four LEDs on the CityFibre ONT:
- LED 1 (Left) – Power, can be Green/Red/Amber
- LED 2 – Broadband
- LED 3 – Service
- LED 4 (Right) - Ethernet
Normal state of the LEDs
When working properly this is the state each light should be in, indicating a good connection/service:
- Power: Solid Green - Device has booted up ok
- Broadband: Solid Green - physical connection is established to the fibre
- Service: Solid Green - Internet service has been established
- Ethernet: Green - connected to your router
Diagnostics
There is no end user access to the ONT's configuration or status pages. There are two things a customer can perform though:
- Reboot
- Reset
Reboot the CityFibre ONT
You can pull the power cable, wait a few seconds and plug it back in again. This is safe to do and will mean the ONT reboots and reconnects to the fibre network.
Reset the CityFibre ONT
Use a paperclip, or similar, and hold in the reset switch for 10-15 seconds. This will cause a reboot and factory reset of the ONT.