FireBrick 2700 Configuration run-through: Difference between revisions
(Added static route info in 'Accessing the Modem', based on actual experience.) |
|||
=Other Things=
==Accessing the Modem==
The modem, or ADSL router in bridge mode, will also have a LAN IP that you can use to get to it's config pages etc. eg, the ZyXEL P660-R will still have a LAN setting, with an IP set. For the purpose of this example, let's assume the P-660R is on 192.168.1.2 mask 255.255.255.0.
In order to talk to the Modem from the LAN side of the FireBrick, a Subnet on the FireBrick needs to be made.
This subnet would be on the WAN Interface, eg:
<syntaxhighlight>
<interface name="WAN" port="WAN1">
<subnet ip="
</interface>
</syntaxhighlight>
And the assuming the Modem is on 198.51.100.1, you'll be able to access it from the LAN side of the FireBrick.▼
This will put the FB on 192.168.1.1, and allow the FB to route IP packets from your LAN interface *to* the Modem on the WAN interface. However, at this stage, you may find the modem does not have a *return* route to your LAN addresses, so no packets return. You'll be unable to ping the modem yet. We need to set a static route on the modem, pointing back to the FB.
For example, on the ZyXel P-660R, you will have configured the IP and Netmask on the 'LAN' tab. But there's no 'Gateway', so we must go to 'Advanced' -> 'Static Routes' tab, and create one. Enter it as follows: IP, Mask = base address of your internal LAN; eg: 81.xx.xx.0, 255.255.255.192. The 'Gateway' address is pointing back at the FB, eg 192.168.1.1. Check the box to Activate the route, and that's it done.
▲
|