IPsec Firewall

If there is no NAT involved, you need:

• UDP port 500 for the IKE control channel
• IP protocol ESP (50) for the data channel.

If NAT has been detected, or you force IKE to believe NAT is present (see below) you need:

• UDP port 4500 only (no need for protocol ESP).
• You may need UDP port 500 too, to allow the initial contact to be made - though as soon as NAT is detected (or it has been forced) IKE switches to 4500.
• UDP 4500 for IKE

The config force-NAT option [Note the capitalisation ] can be used to force IKE to treat the connection as if it was NATed. This is in the top-level ipsec-ike config item and you need "Show all" on the UI.

Here is an example rule set for allowing IPsec in to a FireBrick:

   <rule-set name="IPsec" source-interface="pppoe" target-interface="self" no-match-action="continue" comment="Allow IPsec connections from PPP to the Brick">
      <rule name="IKENAT" target-port="500 4500" protocol="17" action="accept" comment="Internet Key Exchange - network protocol used by IPSec"/>
      <rule name="ESP from anywhere" protocol="50" action="accept" comment="Encap Security Payload"/>
   </rule-set>