Configuring Yealink DECT phone for AAISP

Relevant to: Yealink W60B

The Yealink W60B is a DECT base station aimed at small and medium-sized businesses. It's main specifications are:

Up to 8 handsets
Up to 8 SIP accounts
Up to 8 simultaneous calls
Support for additional 'repeaters'
IPv4 and IPv6
PoE or Mains plug for power

Credentials

Yealink

	As shipped / unconfigured	Once configured
IP:	DHCP	DHCP
Username:	admin
Password:	admin	contact us

IP address

By default the base unit picks up an IP address using DHCP. You can find the IP address from the Handset:

Press OK –> Select the ‘i’ icon (Status) -> select ‘Base’ -> the IP will be shown

Yealink and Voiceless Settings

click to view settings

On the web interface, go to:

Account ->

Yealink Settings
Setting	Value
Line Active	Enabled
Label	AAISP (or what ever you like)
Display Name	Your Name (or what ever you like)
Register Name	Your phone number, +44...
Username	Your phone number, +44...
Password	Your SIP password
Server Host	voiceless.aa.net.uk
Server Expires	600

Check the SIP registration status:

Go to:

Status -> Yealink_W53P_SIP_Config.png

You should the the account Status as 'Registered'

Handset Assignmnent

Handset Assignment

Then you'll need to assign this account to a handset for incoming calls, this is set under

Account -> Number Assignment

Here you can assign which of your (up to) 8 SIP accounts are to ring which of your (up to) 8 handsets!

Audio settings

In menu:

Settings -> Telephony -> Audio" select "Voice Quality -> Own Codec preference".

For "IP1" (Or whatever you call the AAISP account) remove all codecs except "G.711 a law". This setting will generally give the best audio quality.

Other settings

If there are problems with recognition of DTMF tones by other systems consider setting "RFC2833" and avoid using "Audio". in the setting:

Settings -> Telephony -> Advanced Settings -> RFC2833

Check that the Number Plan/Assignment is set to use the VoIP rather than the fixed (pstn) line:

Settings - Number Assignment Set the VoIP for outgoing, and set the others to suit...

It may not say the above and Automatic negotiation of DTMF transmission will need to be Yes

Set the Tone Pattern to be UK:

Settings -> Management -> Local Settings -> Tone Pattern=United Kingdom

You may want to remove, or edit, the 'Info Services' - this is the information such as weather and so in that can be displayed on the screen:

Settings - Info Services

Quirks

We have seen odd things with a S685IP (Firmware version: 022270000000 / 043.00) where it would register, but not pass calls. A reboot of the base station fixed this.

Firewall & Security

You will also want to set up firewall rules, as per the VoIP Firewall page.
Also see the VoIP Security page for information about securing your VoIP service.