CityFibre ONT: Difference between revisions

Back up to the Routers Category
From AAISP Support Site
Line 8: Line 8:
=LEDs=
=LEDs=


==Overview==
===Overview===
There are four LEDs on the CityFibre ONT:
There are four LEDs on the CityFibre ONT:


Line 16: Line 16:
*LED 4 (Right) - Ethernet
*LED 4 (Right) - Ethernet


==Normal state of the LEDs ==
===Normal state of the LEDs ===
When working properly this is the state each light should be in, indicating a good connection/service:
When working properly this is the state each light should be in, indicating a good connection/service:



Revision as of 20:15, 1 August 2022


CityFibre ONT

LEDs

Overview

There are four LEDs on the CityFibre ONT:

  • LED 1 (Left) – Power, can be Green/Red/Amber
  • LED 2 – Broadband
  • LED 3 – Service
  • LED 4 (Right) - Ethernet

Normal state of the LEDs

When working properly this is the state each light should be in, indicating a good connection/service:

  • Power: Solid Green - Device has booted up ok
  • Broadband: Solid Green - physical connection is established to the fibre
  • Service: Solid Green - Internet service has been established
  • Ethernet: Green - connected to your router

Diagnostics

There is no end user access to the ONT's configuration or status pages. There are two things a customer can perform though:

  • Reboot
  • Reset

Reboot the CityFibre ONT

You can pull the power cable, wait a few seconds and plug it back in again. This is safe to do and will mean the ONT reboots and reconnects to the fibre network.

Reset the CityFibre ONT

Use a paperclip, or similar, and hold in the reset switch for 10-15 seconds. This will cause a reboot and factory reset of the ONT.