3
edits
Router - Cisco IPv6 Native Config: Difference between revisions
Router - Cisco IPv6 Native Config (view source)
Revision as of 10:05, 27 February 2015
, 27 February 2015no edit summary
No edit summary |
|||
| (14 intermediate revisions by 6 users not shown) | |||
|
<pre>
</pre>
<pre>
</pre>
EDIT - Feb 2015 - Above didn't work for me, alternative config below
<pre>
! Feb 2015 - Cisco 1841 / FTTC
! LAN Port (I used default /64 on clueless)
!
interface FastEthernet0/0
ipv6 address 2001:8B0:xx:xxxx::1/64
ipv6 enable
ipv6 nd other-config-flag
ipv6 dhcp server ipv6dhcp_pool
!
! Below gives out IPv6 DNS to clients
!
ipv6 dhcp pool ipv6dhcp_pool
dns-server 2001:8B0::2020
dns-server 2001:8B0::2021
</pre>
<pre>
</pre>
02/11/2011
The above config didn't work for me I had to create a new /64 via Clueless and add this here as an IP address
<pre>
</pre>
I would also add the following traffic-filter to the dialer interface
<pre>
</pre>
EDIT Feb 2015 - Alternative config below
<pre>
! Feb 2015 - Cisco 1841 / FTTC
! WAN
!
interface Dialer0
ipv6 address dhcp rapid-commit
ipv6 enable
</pre>
<pre>
</pre>
ipv6 traffic-filter outboundfilters-ipv6 out
</pre>
If you include the "deny any any" line a "show access-lists ..." will show the number of
packets that have hit that line. Thus you can tell if a problem exists because
the packets are not passing through the access list or failure to communicate is
because of some other problem.
[[Category:3rd Party Routers|Cisco]] [[Category:IPv6]]
| |||