12,270
edits
VoIP Phones - Yealink DECT: Difference between revisions
m
→Handset Assignmnent
| (12 intermediate revisions by the same user not shown) | |||
|
<indicator name="VoIPConfiguring">[[File:menu-voip.svg|link=:Category:VoIP Phones|30px|Back up to the VoIP Configuring page]]</indicator>
__NOTOC__
[[Image:W53P-1.png|thumb|Yealink W60B base and handset]]
= Configuring Yealink DECT phone for AAISP =
!Password:
| admin
|contact us
|-
!PIN:
| 0000
|contact us
|}
The PIN is used to register handsets to the base station, and for the handset to access settings from the base station.
= IP address =
|600
|}
Repeat this for any other accounts you want to add.
===Check the SIP registration status:===
[[File:Yealink W53P Hanset Assignment.png|thumb|Handset Assignment]]
===Handset
Here you can assign which of your (up to) 8 SIP accounts are to ring which of your (up to) 8 handsets! You can also make up to 8 calls at once, so a single base station can support a small office of people.
Account -> Number Assignment
Say you have an incoming call that you've answered, and you want to transfer it to someone else and introdice the caller as you go...
* '''Answer''' the incoming call, and find out who they want to be transferred to
*Press the '''TRAN''' button
**At this point the caller is put on hold
*'''Enter in the extension number''' or full number of who you want to transfer the call to
*Press the '''Green dial''' button
**At this point you will be ringing the third party
**If no answer, then you can press the button under '''End''' to go back to the
**At this point you can also Blind transfer the call, by pressing the button under '''Transfer'''
*Once answered, you can introduce the original caller and press the button under '''Transfer'''
==DND - Do not disturb==
You can enable/disable DND via the handset for each of the SIP accounts allocated to the Yealink handset:
OK --> Call Features (orange) --> Do Not Disturb
==Factory reset the Yealink DECT Base Station==
There are a few ways to factory reset the Yealink base station:
===From web ui===
Settings -> Upgrade --> Reset
===From a connected handset===
OK -> Settings -> System Settings -> Base Reset
You'll need to know the PIN (default is 0000)
===From the actual base station===
# Unplug the power
# Press and hold the Connect button
# Whilst holding, plug in the power
# Wait until all three lights on the base station are showing as solid green
# Release the connect button
# Wait a further 5 minutes
# Then, reboot the base station by unplugging it from power and plugging it back in
=Registering an additional Handset=
# Power up handset
# Press the button under 'Reg'
# Hold the button on the Base for 3 seconds
# Handset should then initialise
# Go to the Base station UI and set up the new account:
# Account - Number Assignment - or set up a new account:
## Account - Set Account2 --> Fill in details
## Account - Handset name --> Set the name
==Firewall & Security==
| |||