12,271
edits
VoIP Phones - Yealink DECT: Difference between revisions
m
no edit summary
mNo edit summary |
|||
| (13 intermediate revisions by 2 users not shown) | |||
|
<indicator name="VoIPConfiguring">[[File:menu-voip.svg|link=:Category:VoIP Phones|30px|Back up to the VoIP Configuring page]]</indicator>
[[Image:W53P-1.png|thumb|Yealink W60B base and handset]]
= Configuring Yealink DECT phone for AAISP =
*PoE or Mains plug for power
*Transfer button (allows assisted or blind transfers to other SIP extensions/external numbers)
*Docs/firmware from Yealink: https://support.yealink.com/en/portal/docList?archiveType=document&productCode=b0040cca269c2a01
*[https://www.yealink.com/upfiles/products/datasheet/Yealink-W60B-Datasheet.pdf Datasheet]
You should the the account Status as 'Registered'
<gallery widths=
Yealink_W53P_SIP_Config.png|VoIP Account settings
</gallery>
You have the flexibility to decide which VoIP account should ring which handset, and also which account the handsets use to make their outgoing calls.
<gallery mode="packed" widths=250px heights=250px mode="nolines" caption="Screenshots of number assignment page">
Yealink W53P
Yealink-4handsets1number.png|Four Handsets sharing one VoIP Account
</gallery>
OK --> Call Features (orange) --> Do Not Disturb
==Factory reset the Yealink DECT Base Station==▼
=Registering an additional Handset=▼
# Power up handset▼
# Press the button under 'Reg'▼
# Hold the button on the Base for 3 seconds▼
# Handset should then initialise▼
# Go to the Base station UI and set up the new account:▼
# Account - Number Assignment - or set up a new account:▼
## Account - Set Account2 --> Fill in details▼
## Account - Handset name --> Set the name▼
If you have lost the password you will have to factory reset the base station, and the default username and password will then work, and you'll need to configure the unit again.
There are a few ways to factory reset the Yealink base station:
===From web ui===
If you know the password!
Settings -> Upgrade --> Reset
# Wait a further 5 minutes
# Then, reboot the base station by unplugging it from power and plugging it back in
▲=Registering an additional Handset=
▲# Power up handset
▲# Press the button under 'Reg'
▲# Hold the button on the Base for 3 seconds
▲# Handset should then initialise
▲# Go to the Base station UI and set up the new account:
▲# Account - Number Assignment - or set up a new account:
▲## Account - Set Account2 --> Fill in details
▲## Account - Handset name --> Set the name
[[Category:VoIP Phones|
| |||