Line State Colours: Difference between revisions

Revision as of 16:08, 14 July 2016

Line colours are based on the last cause code reported by RADIUS which depends on whether the line is on-line or off line and why.

The cause codes are defined by the standard (RFC2866) and do not always fit all circumstances.

Logged in	Line is logged in, no error
User Request	PPP restart or termination from far end, or L2TP session close from far end
Lost Carrier	LCP echo timeout
Lost Service	L2TP session close with specific message indicating loss of sync
Idle Timeout	Used to indicate a lost session, e.g. NAS crash
Session Timeout	Session timeout reached (normally after one hour on a blocked login)
Admin Reset	Manual or remote session or tunnel termination
Admin Reboot	LNS reboot or other RADIUS accounting issue
Port Error	L2TP relay failure, or L2TP tunnel level close
NAS Error	Any unknown internal error in LNS including no negotiation slots (too busy)
NAS Request	Session steering (directed to different LNS)
NAS Reboot	Not used
Port Unneeded	Try another response on RADIUS (steering)
Port Pre-empted	Same login twice. As login is based on circuit ID this is not normally seen.
Port Suspended	Line dropped because of an attack
Service Unavailable	RADIUS timeout
Callback	Not used
User Error	Any sort of PPP negotiation failure, or an authentication failure and also some L2TP negotiation errors
Host Request	Not used
Blocked	Line is logged in but blocked due to bad password or blocked login
Invalid	Line not valid (not installed, or is ceased)

@@ Line 1: / Line 1: @@
+<indicator name="Front">[[File:Menu-cog.svg|link=:Category:Line Settings|30px|Back up to the Broadband Line Settings]]</indicator>
 Line colours are based on the last cause code reported by RADIUS which depends on whether the line is on-line or off line and why.
@@ Line 67: / Line 69: @@
 |Line not valid (not installed, or is ceased)
 |}
+[[Category:Line_Settings]]