Setting up the XClaim Xi-2/3: Difference between revisions

(3 intermediate revisions by 2 users not shown)

Line 14:

[[File:Harmony_admin_pw.png|200px|center]]

3. Set your SSID , or skip this step.

3. Set your SSID, or skip this step.

4. Hit 'Finish'. On the following screen, hit 'search for Access Points'. ''This step can be slow, if it hangs when searching, close the app and then open it again''. Once done, you should see your new access point in the list. Click it.

Line 20:

[[File:harmony_ap_list.png|200px|center]]

5. From here you can set your SSID and Channel Width settings. Once you are happy with these settings, hit the save button at the top right. The ~~access point~~ will then apply these settings and restart which will take a few minutes.

5. From here you can set your SSID and Channel Width settings. Once you are happy with these settings, hit the save button at the top right. The app will then apply these settings and restart the access point which will take a few minutes.

[[File:harmony_ap_configuration.png|200px|center]]

Line 33:

3. Once logged in you can modify the settings for the XClaim access point to your liking.

==Factory Default Admin Username/Password==

The username and password below is only needed if you wish to configure individual Access Points manually. If you wish to use the Xclaim Cloud Manager then you don't need to use these credentials as the Cloud Manager will take over the configuration.

{|class="wikitable"

!colspan="3"|Default/Factory Password

|-

!IP Address:

|colspan="2"|192.168.0.1 or DHCP from your LAN

|-

!Web Interface Username:

|xclaim-mfg

|-

!Web Interface Password:

|mfg-admin12

|}

==Factory Reset==

Hole in the reset button for 8 seconds, release and it will restart

[[Category:Other Hardware]]