L2TP Client: Routerboard: Difference between revisions
Content deleted Content added
NAT to l2tp-aaisp matching the instructions above |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 104: | Line 104: | ||
We will now create the L2TP tunnel that we'll use to connect to A&A's L2TP server. We'll leave it disabled until after we've set up the Firewall, so we don't expose our router to the internet until we're finished configuring it. |
We will now create the L2TP tunnel that we'll use to connect to A&A's L2TP server. We'll leave it disabled until after we've set up the Firewall, so we don't expose our router to the internet until we're finished configuring it. |
||
Confirm that you have the right L2TP username and password before you do this section. If you're not sure, you can get these from your L2TP service page on the control pages at https://control.aa.net.uk |
|||
# From the WinBox menu, open '''Interfaces''', and use the '''+''' button to add a new "L2TP Client". |
# From the WinBox menu, open '''Interfaces''', and use the '''+''' button to add a new "L2TP Client". |
||
| Line 548: | Line 550: | ||
add action=masquerade chain=srcnat comment=\ |
add action=masquerade chain=srcnat comment=\ |
||
"NAT: masquerade 192.168.88.0/24 to l2tp-aaisp's address" out-interface=\ |
"NAT: masquerade 192.168.88.0/24 to l2tp-aaisp's address" out-interface=\ |
||
l2tp-aaisp src-address=192.168.88.0/24 |
|||
/ipv6 address |
/ipv6 address |
||
add address=2001:8b0:db8:acb1::1 interface=bridge-l2tp-lan |
add address=2001:8b0:db8:acb1::1 interface=bridge-l2tp-lan |
||