Stopping Open DNS - ZyXEL P660R-D1: Difference between revisions

Revision as of 09:25, 27 Haziran 2013

The factory setting for this router on older firmware is for DNS to be open on the WAN. This will be changed when configured by AAISP, but if it is configured from new, or reset, then WAN side DNS may need to be disabled. This can be done from the web interface and setting DNS Access Status to LAN. Go to:

> Advanced - Remote MGMT - DNS - LAN

What is the IP address of the router?

Most routers supplied by AAISP will have a sticker or card on the base of the router which will have the IP address.

What is the admin username and password?

Most routers supplied by AAISP will have a sticker or card on the base of the router which will have the password. On the ZyXEL the username is admin.

I am Unable to get to the web interface?

Sometimes the webserver on the router stops working, try turning the router off and on again.

Changing this via Telnet

If you still can't access the router web pages, then you can do this via telnet by running the following commands:

sys server load 
sys server access dns 2 
sys save

This also applies to the P-660HW-T1 v2 Router

Also see:

Router_-_ZyXEL_P660R-D1

@@ Line 9: / Line 9: @@
 Most routers supplied by AAISP will have a sticker or card on the base of the router which will have the IP address.
-==What is the admin username and password==
+==What is the admin username and password?==
 Most routers supplied by AAISP will have a sticker or card on the base of the router which will have the password. On the ZyXEL the username is admin.
-==Unable to get to the web interface?==
+==I am Unable to get to the web interface?==
-If you are unable to get to the web interface, then try turning the router off and on again.
+Sometimes the webserver on the router stops working, try turning the router off and on again.
 ==Changing this via Telnet==