Category:Technicolor DGA0122: Difference between revisions

Revision as of 17:12, 8 December 2020

Technicolor DGA0122

4x 10/100M/1,000M ports.
Modem supports VDSL (FTTC) and ADSL/ADSL2+ (Not G.Fast)
WiFi is:
- 2.4GHz WiFi-4, (2x2) IEEE 802.11n
- 5GHz, WiFi-5, (3x3) IEEE 802.11ac
2 FXS ports, for connecting an analogue phone to a VoIP account
MTU 1500 when in bridge mode not possible.
File:DGA0122 v1.2 public.pdf

ADSL1, ADSL2+
VDSL (FTTC)
G.Fast - using the Ethernet WAN port connected to an existing G.FAST modem
FTTP, FTTPoD - using the Ethernet WAN port to the fibre termination 'modem'

Default/Factory Password
IP:	192.168.1.1 (will change once configured if you have a block of IPv4 addresses)
Username:	admin (or engineer for some superpowers)
Password:	Before configured it will be as stated on the rear panel. Once configured it will be the one printed on the A&A card.
WiFi Password:	Before configured it will be as stated on the rear panel as 'ACCESS KEY'. Once configured it will be the one printed on the A&A card.

We've identified a couple of bugs and have listed them here:

The following 16 pages are in this category, out of 16 total.

The following 9 files are in this category, out of 9 total.

@@ Line 17: / Line 17: @@
 *ADSL1, ADSL2+
 *VDSL (FTTC)
-*''G.Fast''  - using the Ethernet WAN port connected to an existing G.FAST modem
+*''G.Fast''  - using the Ethernet WAN port connected '''to an existing G.FAST modem'''
-*''FTTP, FTTPoD'' - using the Ethernet WAN port to the fibre termination 'modem'
+*''FTTP, FTTPoD'' - using the Ethernet WAN port '''to the fibre termination 'modem''''
 ==Factory Default Admin Username/Password==