DGA0122 Disable SSH: Difference between revisions
Content deleted Content added
mNo edit summary |
mNo edit summary |
||
| Line 8: | Line 8: | ||
The CLI is fairly minimal. |
The CLI is fairly minimal. |
||
[[File:Technicolor-ssh-disable.png|thumb|ssh disable command]] |
|||
ssh can be disabled if you want, you can do this via ssh. ssh in to the router and paste the following which will disable the access: |
ssh can be disabled if you want, you can do this via ssh. ssh in to the router and paste the following which will disable the access: |
||
set InternetGatewayDevice.Services.X_000E50_AccessManagement.SSH.ServerAccess.1.Enable 0 |
set InternetGatewayDevice.Services.X_000E50_AccessManagement.SSH.ServerAccess.1.Enable 0 |
||
The command will run, and should report no error. type exit to exit from the ssh session. |
The command will run, and should report no error. type exit to exit from the ssh session. (see screenshot) |
||
Then reboot the router. |
Then reboot the router. |
||
Revision as of 12:35, 1 September 2022
This probably applies to most Technicolor routers.
ssh is enabled from the LAN, and can be accessed using the engineer user and the admin password.
The CLI is fairly minimal.
ssh can be disabled if you want, you can do this via ssh. ssh in to the router and paste the following which will disable the access:
set InternetGatewayDevice.Services.X_000E50_AccessManagement.SSH.ServerAccess.1.Enable 0
The command will run, and should report no error. type exit to exit from the ssh session. (see screenshot)
Then reboot the router.
Then when you try to ssh, you'll get:
ssh: connect to host 192.168.1.1 port 22: Connection refused
To revert the change, you'll need to reset the router and re-configure.