IPv6 Configuration: Difference between revisions
Content deleted Content added
| Line 24: | Line 24: | ||
[[Category:IPv6]] [[Category:Configuring]] |
[[Category:IPv6]] [[Category:Configuring]] |
||
==FireBrick 2500/2700== |
== FireBrick 2500/2700 == |
||
It's quite easy.... |
|||
Assuming you have an IPv6 block allocated to your line on Clueless and you're using the FB for PPPoE, then all the FB config needs is: |
It's quite easy.... Assuming you have an IPv6 block allocated to your line on Clueless and you're using the FB for PPPoE, then all the FB config needs is: |
||
An IPv6 address on the LAN subnet |
|||
*An IPv6 address on the LAN subnet |
|||
*ra="true" in the subnet |
|||
Revision as of 09:16, 6 January 2011
Related Pages on the A&A Website:
Useful Blog/HOWTO Entries
Consumer CPE Equipment
The following equipment has been successfully used as an IPv6 Router for home use
- Linksys NSLU2 running OpenWRT 10.03 (Backfire) with a Netgear DM111P ADSL2+ DSL Modem
- Netgear DG834v2 running OpenWRT 8.09 (Kamikaze)
IPv6 over IP Tunnelled Connections
See also the configuration examples on the IPv6 Knowledge-base page referenced above.
FireBrick 2500/2700
It's quite easy.... Assuming you have an IPv6 block allocated to your line on Clueless and you're using the FB for PPPoE, then all the FB config needs is:
- An IPv6 address on the LAN subnet
- ra="true" in the subnet