VoIP Phones - Gigaset N300: Difference between revisions

Line 7:

|No

|-

|Tested on FireBrick SIP Server

|Tested on [[FireBrick SIP]] Server

|Yes

|-

|IPv6 Support

|[[IPv6]] Support

|No

|}

These notes are the same for configuring an S685IP, A580IP and N300A too.

Update to new firmware here https://gigaset.atlassian.net/wiki/display/GPPPO/N510+IP+PRO+Release+notes+42.192;jsessionid=F1311720EDB5590D7D07F46655951B91

If there are problems in setting up the base station it is easiest to start from a factory reset condition. This can be achieved by holding the blue button on the front of the base unit while power cycling it. After this the handset will need to be re-registered with the base unit (hold the blue button on the base unit while power cycling the handset). The pin should be changed from its default value of 0000 using the handset.

Line 32:

Line 34:

{| class="wikitable"

!colspan="2"|Gigaset N300 Settings

!colspan="2"|[[Gigaset]] N300 Settings

|-

!Setting

Line 105:

Line 107:

All the other fields can be left as they are unless you are using NAT in which case the "Stun enabled" button should be selected and the "Stun server" set to stun.aaisp.net

When everything is entered click on the "Set" button. The display will return to the "Settings -> Telephony -> Connections" menu. Check that "IP1" is active and that the status is "Registered". You may wish to disable "Gigaset.net" in this menu. It should now be possible to make and receive calls.

When everything is entered click on the "Set" button. The display will return to the "Settings -> Telephony -> Connections" menu. Check that "IP1" is active and that the status is "Registered". You may wish to disable "[[Gigaset]].net" in this menu. It should now be possible to make and receive calls.

==Firewall & Security==