Router - ZyXEL P660R-D1
Overview
The ZyXEL P660R-D1 is a nice little ADSL router, ideal for sites that have their own firewall router. It can be configured for routing or bridging.
| LED Status | ||||
|---|---|---|---|---|
| Steady | Flashing | Blink | Off | |
| Power | Power on | Power off | ||
| Ethernet | ||||
| DSL | In Sync | Attempting sync | Traffic | No Sync |
| Internet | PPP down | PPP online | ||
Default Admin Username/Password
| Default/Factory Password | |
|---|---|
| Username: | admin |
| Password: | 1234 |
| AAISP configured Password | |
| Printed on card with router | |
Basic Configuration for PPPoA
This will cover BT, TT, BE lines.
Bridge config
To configure the ZyxEL as a bridge, the settings to use are as follows, and these settings are set in:
Network > WAN > Internet Connection
Also see the screenshot below:
Name: AAISP (But can be anything) Mode: Bridge Encapsulation: RFC 1483 Multiplexing: LLC (VC may work on 20cn, but stick with LLC) VPI: 0 VCI: 38 ADSL modulation type: Multimode
Netbios Filter
Closing Open DNS
Closing WAN HTTP
By default ZyXELs have their web interface open to the LAN and the WAN. This can be changed on the web interface to only allow access from the LAN.
There are a couple of options for securing WAN HTTP access:
- Only Allow Access From the LAN
- Allow LAN and WAN access but use a different Port
Advanced - Remote MGMT - WWW - LAN
