VMG1312-B10A: AAISP Configuration

From AAISP Support Site
Revision as of 21:45, 28 Mayıs 2015 by AA-Andrew (talk | contribs)

AAISP configure routers via TR-069 protocol. We generate a config file and this is sent to the router. Firmware updates are also able to be sent to the router.

Customers are free to alter the configuration as supplied, sending a configuration from the Control Pages will overwrite any settings changed though.

Here is an overview of the settings that are modified from the default:

  • Configure WAN interface (Further Settings on Control Pages: ADSL/FTTC, Bridge or WAN on port 4 (FTTP))
  • Configure PPP settings as per the service
  • Configure DHCP (Further Settings on Control Pages, Default=All IPs using AAISP DNS servers or as set on Control Pages)
  • Configure LAN subnet if line has a block of public IPs. (else default is 192.168.1.1)
  • Configure WiFi (Further Settings on Control Pages: SSID, Password or disable WiFi)
  • Configure WiFi for 20Mhz instead of the 40Mhz default (see VMG1312: WiFi Tips)
  • Configure Firewall on/off (Settings on Control Pages, Default=Enabled)
  • Configure TR-069 so the router can be managed by AAISP (we give customer the same controls as staff get)
  • Configure Local logging (on router) to log: System, PPPoE, XDSL, Internet, Attack, Account. (added 2015-05-29)
    • To view log: WebUI: System Monitor - Log or via telnet/ssh CLI: syslog dump system.
  • Disable NAT, if customer has a public IP block
  • Disable SNMP
  • Disable 3G backup
  • Change NTP servers to be time.aa.net.uk and 0.uk.pool.ntp.org
  • Change 'supervisor' password (Setting on Control Pages)
  • Change 'admin' password (Setting on Control Pages)
  • Change Remote Management Options (Further Settings on Control Pages)
  • Change QoS to give upstream priority based on 'Packet Length' (See: VMG1312: QoS)
  • Change 'Deny Ping Response' to Disable, to allow the router to reply to ping.
  • Disable the default QoS Classes (See: VMG1312: QoS)
  • Remove the default read-only zyuser user


  • Static routes are currently not configured. (Only applicable if you have multiple public IP blocks and need them routed to a secondary router. These can be configured manually though.

This list may not be exhaustive, and may change over time.


Notes

DOS protection is left enabled - this may give some unexpected results, eg the router will only reply to 20 pings before it stops replying.

DOS protection settings as described in the user manual
Retrieved from ‘http://support.aa.net.uk/index.php?title=VMG1312-B10A:_AAISP_Configuration&oldid=9511’