L2TP Client: OpenWRT with Policy Based Routing

From AAISP Support Site
Revision as of 13:16, 5 March 2024 by David-AA (talk | contribs)

This guide was kindly written by Alan T on 04/04/2024

1 Configure LAN interface
Click Add new interface, select Static address then enter
Device br-lan
IPv4 address 10.0.0.1 or 192.xxx.x.x
IPv4 netmask 255.255.255.0
Firewall Settings lan
DHCP Sever On


WRT001.png

Click Save & Apply, then disconnect your WLAN connection and rejoin, or refresh IP address.



2 Set up WAN Connection
This is depended on your WAN connection; however you will most likely need to connect to it wirelessly in Client mode :like myself, or create a DHCP client on eth0.2 (VLAN 2) interface which should default to untagging VLAN 2 on the WAN :interface.
In most situations you should probably enable Masquerading on the WAN interface (default) which is found under Firewall.

WRT002.png

Retrieved from ‘http://support.aa.net.uk/index.php?title=L2TP_Client:_OpenWRT_with_Policy_Based_Routing&oldid=17223’