VMG1312-B10A: Static Routes

NOTE! Some customers have reported static routes not working. This issue is being looked in to (July 2015). It has been suggested that disabling QoS helped, but this has yet to be verified with other setups.

Static routes can be applied manually. This allows a second block of IP addresses allocated by AAISP to be routed to a router on your LAN on the inside of the ZyXEL router, eg

INTERNET <--> ZyXEL <--> ROUTER <--> LAN

(Note, some people may prefer to set the ZyxEL to Bridge mode, and then have your own Router use PPP to log in. This has the advantage of keeping the ZyXEL config simpler and giving your own router more control over the Internet access.)

The static route can be added via the web interface:

Network Setting -> Routing -> Add new static route

Here is an example:

Creating a Static Route

The new Static route, as shown on the routes page

Firewall

It seems that the firewall will be unaware of the static route, and adding firewall entries to allow the traffic will be ignored. Disabling the firewall will allow the traffic through the ZyXEL to your router. This is normally required anyway, as customers would typically use the firewall features on the internal router.

CLI

From the CLI (telnet/SSH) you can view the route table with:

route show

The list should display immediately, if there are pauses between showing the default routes and the new static then this could be an indication of a problem with DNS look-ups and should not affect the actual routing.