12,271
edits
Line Diagnostics: Difference between revisions
m
→Run PSTN Test
m (→Run PSTN Test) |
m (→Run PSTN Test) |
||
|
Example output:
WLR3Test WLR3_CIDT_Test rds089a006:240448742: Fail FAULT - Dis in exchange ServiceLevel:2, MainFaultLocation:FU, FaultReportAdvised:Y,
AppointmentRequired:N, LineStability:, NetworkStability:, StabilityStatement:
This actually shows a fault, 'Disconnect in exchange'. It is suggesting a fault is to be reported (contact support), but that no appointment is required to me made at the End user premises (as the fault is located at the exchange). However, running the test a little while later gave:
WLR3Test WLR3_CIDT_Test rds089a006:240514264:
Pass Line Test OK. Dial tone OK ServiceLevel:2, MainFaultLocation:OK, FaultReportAdvised:N, AppointmentRequired:N, LineStability:Stable,
NetworkStability:Stable, StabilityStatement:Stable - no adverse line test history. CP may request an Engineer visit to investigate, test and demonstrate with the EU.
Routine test & fault data available at Customer Diagnostic Tool on INFORMe under MIS>Artisan>CDT.
If no fault is found clear RWT and apply Time Related Charges.
| |||