Status Tests: Difference between revisions

Line 1:

These tests will show the sync status of the line and as well as some other details such as errors etc. They may also state if a fault has been identified.

⚫

==BT Sync Status Test==

⚫

=BT ADSL Sync Status Test=

{{CPbox|#Click on the line you want to run the test on

#Click on the Status Test button}}

⚫

*Available on BT ADSL lines.

==Availability==

⚫

Available on BT ADSL lines.

This will report back the current sync status of the line, including error counts. This is non-intrusive and should not cause the line to drop.

Example output:

==Example output:==

<pre>

BT Test xDSL Status Check:Pass Standalone sub test passed successfully. Pass OK. Circuit In Sync.

Line 23:

Line 27:

This one shows that the line has a '''FTB''' - Fault Threshold Breach - ie, the Down Sync ('''6,144''') is less than the Fault Threshold Rate ('''6,374'''). The line speed is below what it should be and would need looking in to. See: [[:Category:Slow_ADSL]]

==FTTC End to End Test==

=BT FTTC End to End Test=

{{CPbox|#Click on the line you want to run the test on

#Click on the E2E Test button}}

==Availability==

⚫

Available on BT FTTC/FTTP lines.

⚫

*Available on BT FTTC/FTTP lines.

This will run FTTC/FTTP specific tests and will suggest if it finds a fault or not.

Example result:

==Example result:==

<pre>

BT Test E2E Access Test/DCN:Inconclusive OR test pass. Unable to find the fault.