Category:Technicolor DGA4134: Difference between revisions

(3 intermediate revisions by 2 users not shown)

Line 6:

[[File:DGA4134-front.png|thumb|Front]]

These pages are about the Technicolor DGA4134 and DGA4135 routers. The two models are near identical. The DGA4134 was EOL Summer 2023 and replaced by the DGA4135, with the DGA4135 having a different WiFi chip, but the rest remains the same.

These pages are about the Technicolor DGA4134. .

==Technicolor DGA4134==

==Technicolor DGA4134 / DGA4135==

This router was introduced as a stop-gap for the DGA0122 in October 2021 due to supply shortages with the DGA0122.

The DGA4134 and the DGA0122 are ~~very~~ similar. They look physically different, but the user interface, and physical ports are very similar. The DGA4134 ~~has~~ WiFi 6 though. Some of the support pages for the DGA0122 are also relevant to the DGA4134.

The DGA4134 and the DGA0122 are similar. They look physically different, but the user interface, and physical ports are very similar. The DGA4134/DGA4135 have WiFi 6 though. Some of the support pages for the DGA0122 are also relevant to the DGA4134/DGA4135.

Works well with the 'Technicolor OWA0131 WiFI Extender'.

Line 18:

Line 19:

*1x 1 GE WAN port

*Modem supports VDSL (FTTC) and ADSL/ADSL2+ (Not G.Fast)

*WiFi is:

**2.4GHz (2x2) Wi-Fi 6 (IEEE 802.11ax)

**5GHz (4x4) Wi-Fi 6 (IEEE 802.11ax)

Line 30:

Line 31:

*ADSL1, ADSL2+

*VDSL (FTTC)

*''G.Fast'' - connect the red Ethernet WAN port '''to ~~an existing~~ G.FAST modem'''

*''G.Fast'' - connect the red Ethernet WAN port '''to a G.FAST modem'''

*''FTTP, FTTPoD'' - connect the red Ethernet WAN port '''to ~~the~~ fibre termination ~~'modem'~~'''. Suitable for 1G/s FTTP, see note on speeds below.

*''FTTP, FTTPoD'' - connect the red Ethernet WAN port '''to your fibre termination unit'''. Suitable for 1G/s FTTP, see note on speeds below.

'''Bridge mode:''' The automatic A&A configuration will not configure these routers as 'bridge'. If you want to use your own PPPoE router. In this case our basic ZyXEL is a better choice, or you can configure it manually: https://support.aa.net.uk/DGA0122_Bridge_Mode

===Speeds===

Line 47:

!Once configured

|-

!IP:

!IP

|192.168.1.1

|192.168.1.1 or your public block

|-

!Username:

|colspan="2" |admin (or engineer for some superpowers)

|-

!Password:

|rowspan="3"| as stated on the rear panel

|rowspan="3"| as printed on the A&A card

|-

!Wifi Name:

|-

!WiFi Password:

|}