Router - TG582N - Bridge: Difference between revisions

Line 13:

''It doesn't seem possible to make it work without two internet

connections being configured, even though 'Internet2' is disconnected.

I removed it's config and restored, and the ethernet ports didn't want

I removed it's config and restored, and the [[ethernet]] ports didn't want

to come up!''

Line 22:

'''Config file:''' [[File:AA_TG582n_Bridge_config.ini.zip.zip]]

Another Customer entry:

To put the router into proper bridge mode, telnet in and enter these commands

:ppp relay flush

:ppp flush

:eth flush

:atm flush

:atm phonebook flush

:saveall

:atm phonebook add name=BrPPPoE_ph addr=0.38

:atm ifadd intf=BrPPPoE_atm

:atm ifconfig intf=BrPPPoE_atm dest=BrPPPoE_ph encaps=vcmux ulp=mac

:atm ifattach intf=BrPPPoE_atm

:eth bridge ifadd intf=BrPPPoE_br

:eth bridge ifconfig intf=BrPPPoE_br dest=BrPPPoE_atm

:eth bridge ifattach intf=BrPPPoE_br

:service system modify name=DHCP-S state=disabled

:wireless radio state=disabled

:saveall

[[IPv6|IPV6]] not tested with the above setup although, in theory, it should work as all the above is, is a clean bridging setup.

I have recently migrated from BE and their router had a 'half-bridge' mode where the router would only use the dhcp allocated WAN IP address and route the allocated subnet onwards.

I am investigating this setup on the [[TG582N]]. Main advantage is that you can then still easily access the router.

==Other pages regarding this router:==

<ncl style=bullet maxdepth=5 headings=bullet headstart=2 showcats=1 showarts=1 showfirst=1>Category:Router TG582N</ncl>

<ncl style=bullet maxdepth=5 headings=bullet headstart=2 showcats=1 showarts=1 showfirst=1>Category:Router [[TG582N]]</ncl>