Search results

Set the NAT flag on the ipsec roaming pool definition. the roaming pool NAT setting should not be set. Normally you

nat mapadd intf=Internet type=nat outside_addr=80.2.2.0/28 inside_addr=80.2.2.0/28

nat=no...

...ROroute H820' router works well with our Data SIMS. The router supports no NAT, and is specified to be more of an 'industrial' device.

...th everything necessary to do PPPoE, mini jumbo frames, firewalling, DHCP, NAT, IPv6 RA, DNS Caching and 6to4/DNS64 if you need it. ...tion (/etc/pf.conf) to enable NAT (replace the range with your chosen IPv4 NAT range):

=== If you are not using public IP addresses (ie NAT): === ...he new call server (e.g. FireBrick FB2900 and many simple NAT routers). If NAT works, then well done, but if not we cannot guarantee to be able to make it

The TL-WR741ND router works, although it can only do NAT, but is very cheap.

...andset loose cable?! Firewall/NAT blocking traffic || Investigate firewall/NAT/ALG ...a few minutes''' || Firewall/NAT/session timeouts || Investigate firewall/NAT/ALG

|Lower is better if behind NAT - eg every 10 minutes (600 seconds) |Lower is better if behind NAT - eg every 30 seconds

Depending on your router setup or NAT. You may wish to enable "Keep Alive" as shown, making sure the interval is To prevent possible SIP spam calls (if your NAT helper is bad or your ATA has a public IP) you should click on "SIP Setting

...and either public Legacy IPv4 addresses on the LAN, or private address and NAT on the FireBrick. In either case you can have public IPv6 addresses on the ...nterlink address block could be private IPv4 addresses but you do not want NAT or fire-walling on the external routers even in that case as it will not ha

...o LANs, e.g., this will allow all traffic to and from Reading and will not NAT the traffic: <rule name="Allow" set-graph="IPSecTraffic" action="accept" set-nat="false" />

...and password and it just connects. Have to mess about with IP / Route and NAT / masquerading a bit to get devices behind the RouterBoard online but that

...want to happen to that traffic - eg, set a new target IP, port and enable NAT. set-nat="true"

Desired outcome: You want the router to have a main NAT's IP block and allocate IPs by DHCP to your LAN, but you want an additional

Finally, set up NAT, so that the private IPv4 addresses on the LAN interface can access the int set nat source rule 100 description "NAT for IPv4 on LAN"

*'''Munin Plugin by Nat Morris''' *'''MQTT Service by Nat Morris'''

...ublic IP address, therefore the SIP is not being put through NAT. (SIP and NAT don't work well together) ==SIP and NAT==

...dresses that are not filtered, not behind Carrier Grade NAT or any sort of NAT. All you need us a router capable of L2TP and an [https://www.aa.net.uk/bro

===NAT?=== ...If so, we use the DDI followed by the contact from the registration. When NAT is used we can't trust the contact for the registration.