Search results

...and password and it just connects. Have to mess about with IP / Route and NAT / masquerading a bit to get devices behind the RouterBoard online but that

...want to happen to that traffic - eg, set a new target IP, port and enable NAT. set-nat="true"

Desired outcome: You want the router to have a main NAT's IP block and allocate IPs by DHCP to your LAN, but you want an additional

Finally, set up NAT, so that the private IPv4 addresses on the LAN interface can access the int set nat source rule 100 description "NAT for IPv4 on LAN"

*'''Munin Plugin by Nat Morris''' *'''MQTT Service by Nat Morris'''

...ublic IP address, therefore the SIP is not being put through NAT. (SIP and NAT don't work well together) ==SIP and NAT==

...dresses that are not filtered, not behind Carrier Grade NAT or any sort of NAT. All you need us a router capable of L2TP and an [https://www.aa.net.uk/bro

===NAT?=== ...If so, we use the DDI followed by the contact from the registration. When NAT is used we can't trust the contact for the registration.

Once done, the device will be set up in IPv4 NAT mode, with an unchanged IP address. You will have basic IPv4 NAT'd internet connectivity at this stage.

This is a rough example for such a config, using NAT on the LAN and [[L2TP]] to AA as the main connection: comment="Public IP address for NAT"/>

...a router or firewall which does some sort of Network Address Translation (NAT). This page tries to explain some of the issues, and why it is often a prob ...icially supported, but generally can be made to work. Due to the nature of NAT, and the numerous implementation and 'fixes' and 'bodges' in routers, it ca

These routers seem to have very short a UDP NAT expiry ~30sec? The port was closing before the phone re-registered, causing

On the NAT Passthrough page, setting the 'Enable PPPoE Relay' to Enable and apply thes

...g port connection through to. '''This part is only needed if you are doing NAT.''' # Navigate to NETWORK SETTING > NAT > Port Forwarding

==NAT== ...as many limitations and is not something we recommend. Even if considering NAT for IPv4 we recommend considering IPv6 addressing on your network as well.

...are the HT802 (which has 2 FXS ports), and the HT81x series (which adds a NAT router, and is available with different == NAT notes ==

...d to run a dual stack environment, but the bits which are "difficult" with NAT can be pushed through IPv6 without issue. Configuration for A&A was relativ

=Default settings and configs just work if NAT is acceptable= *There will be NAT performed by the FireBrick and then again by the dongle

...er/firewall, then you could use this to firewall your network, and provide NAT (if that's what you want to do). The points are similar to the above exampl *Your firewall can be the DHCP server, can run NAT etc. for your LAN

...ress and any external clients, you may also use one of these addresses for NAT (more on that later). == Bringing it all together with NAT, bonding and upstream load balancing in a single router. ==